Has anyone tried the Drewtronics TS1000 tool setter?
Posted: Mon Nov 30, 2020 7:05 pm
Like the subject says, wondering if anyone has tried the Drewtronics TS1000 tool setter?
Did you buy this Tool Setter? Thinking about adding support for such type of probes to the ProbeApp.slodat wrote: ↑Mon Nov 30, 2020 7:05 pm Like the subject says, wondering if anyone has tried the Drewtronics TS1000 tool setter?
I did. I haven’t installed it yet. I can get on it though.swissi wrote: ↑Thu Feb 25, 2021 6:36 pmDid you buy this Tool Setter? Thinking about adding support for such type of probes to the ProbeApp.slodat wrote: ↑Mon Nov 30, 2020 7:05 pm Like the subject says, wondering if anyone has tried the Drewtronics TS1000 tool setter?
-swissi
Please keep us posted how well this device performs. They claim repeatability of 5 micrometer. That means you could measure tool diameters with an accuracy of 0.01mm (0.0004").
Hey did you get this setup? I'm working on setting my drewtronics tool touch up but can't get it to register. Any insight on how you hooked yours up would be awesome!slodat wrote: ↑Thu Feb 25, 2021 7:00 pmI did. I haven’t installed it yet. I can get on it though.swissi wrote: ↑Thu Feb 25, 2021 6:36 pmDid you buy this Tool Setter? Thinking about adding support for such type of probes to the ProbeApp.slodat wrote: ↑Mon Nov 30, 2020 7:05 pm Like the subject says, wondering if anyone has tried the Drewtronics TS1000 tool setter?
-swissi