updated software now no stepper movement (Resolved)

[RKM 3D Designs]

so i updated my software to 4.5 snipped all my settings re-entered everything, now the steppers wont move. the cnc12 software says all is good and when i move the axis in the program the numbers move and such, but no real world movement on the cnc.
any help would be awesome. i attached the report as it sit right now, i wont change anything until i get any info on what needs to change.

report_0035FF8A51A7-0821203657_2020-11-25_14-30-59.zip

(586.2 KiB) Downloaded 138 times

thank you in advance.
RKM

[galyion]

i just had this same issue. did you set the correct connection db25 or screw terminal. if that's not it check your enable pins

[martyscncgarage]

so i updated my software to 4.5 snipped all my settings re-entered everything, now the steppers wont move. the cnc12 software says all is good and when i move the axis in the program the numbers move and such, but no real world movement on the cnc.
any help would be awesome. i attached the report as it sit right now, i wont change anything until i get any info on what needs to change.

report_0035FF8A51A7-0821203657_2020-11-25_14-30-59.zip

thank you in advance.
RKM

Did you resolve this issue?
You didn't provide much information. What drives you have, where they were connected, you could have posted your screen shots BEFORE the upgrade and AFTER the upgrade.
Are you connected to Acorn DB25 or headers?
The report is not enough...

[RKM 3D Designs]

yeah got this resolved sorry fell off the map there. all good machine rocks super good now.