ProbeApp V2: The ultimate solution for Tool Height Offsets

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

ChrisAttebery
Posts: 77
Joined: Mon Dec 07, 2020 2:20 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: 4031
Location: Gilroy, CA
Contact:

Re: ProbeApp V2: The ultimate solution for Tool Height Offsets

Post by ChrisAttebery »

Great minds think alike. I marked my probe to line up with the spindle too.
NovaStar
Posts: 5
Joined: Mon Jul 06, 2020 6:21 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: C143145

Re: ProbeApp V2: The ultimate solution for Tool Height Offsets

Post by NovaStar »

Cost of this App ??
Upnorth
Posts: 28
Joined: Wed Apr 01, 2020 8:23 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: 1702

Re: ProbeApp V2: The ultimate solution for Tool Height Offsets

Post by Upnorth »

Cost of the app is whatever it's worth to you. There is no fixed price you just pay the price you think is fair. I highly recommend this app.
mobilemcclintic
Posts: 2
Joined: Sun Jul 12, 2020 6:24 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none

Re: ProbeApp V2: The ultimate solution for Tool Height Offsets

Post by mobilemcclintic »

Swissi,
I'm having trouble getting z to set to 0 correctly on a corner plate. It I'm not sure where I'm going wrong. If after probing xyz, it goes to x0y0 great. If I tell it to go to Z0 it goes approximately 1/4" or 6 mm lower than the thickness of the corner plate. Any ideas?
mobilemcclintic
Posts: 2
Joined: Sun Jul 12, 2020 6:24 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none

Re: ProbeApp V2: The ultimate solution for Tool Height Offsets

Post by mobilemcclintic »

Sorted, my distance/turn was off on my z-axis. I knew it was something simple.
Post Reply