Page 1 of 1

Fine DRO.....its really FINE

Posted: Sat Oct 31, 2020 5:33 pm
by zz0122
After all the problem I went through, Finally I got the machine setup the way I want.
Now it's time to setup the Precision.
After do some research I end followed the step from the Video below (Thanks Marty).



I draw simple square and circle with Aspire to test the accuracy.
Boy oh boy....its spot on....

100mmX100mm
IMG_7114.jpg
IMG_7114.jpg (22.74 KiB) Viewed 2298 times
IMG_7113.jpg
IMG_7113.jpg (24.1 KiB) Viewed 2298 times
with helped from ProbeApp (Thanks Swissi) , I start my cut.

at 1st I only expected +/- 1% is good enough for me. since im doing this just for hobby not production.
But the final result really surprised me
IMG_7107.jpg
IMG_7107.jpg (33.92 KiB) Viewed 2298 times
IMG_7108.jpg
IMG_7108.jpg (33.34 KiB) Viewed 2298 times
IMG_7110.jpg
IMG_7110.jpg (31.86 KiB) Viewed 2298 times
IMG_7109.jpg
IMG_7109.jpg (33.95 KiB) Viewed 2298 times
IMG_7111.jpg
IMG_7111.jpg (32.98 KiB) Viewed 2298 times
I spent almost 2 hours to get my servo dialed up (New User), but its well worth it.
If anybody have better suggestions, Im all ears...
Now time to tram the machine....

Thanks Everybody...and what a Great Community, I didn't regret spend more money with Acorn instead other board and software.