So I had an issue that stalled my 1 hp lathe and I think but I am not sure that the quick change tool post rotated a little.
Question 1 is there any way to check in the software to see of the tool post did move?
Question 2 IF I do re square it up will the tool offsets change for all my tools?
Tool post moved and tool offsets
Moderator: cnckeith
-
vw_chuck
- Posts: 194
- Joined: Sun Sep 20, 2020 7:34 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0035FF8FEB5F-0708203490
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Tool post moved and tool offsets
Bueller bueller bueller
-
martyscncgarage
- Posts: 9914
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: Tool post moved and tool offsets
You technically crashed your machine. You need to reset everything including a rehome. Nothing magical that can help you...
DID your control fault? It should have if your spindle drive faulted and had a fault output and it was wired to Acorn. Everything should have stopped with the fault.
Marty
DID your control fault? It should have if your spindle drive faulted and had a fault output and it was wired to Acorn. Everything should have stopped with the fault.
Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ
-
vw_chuck
- Posts: 194
- Joined: Sun Sep 20, 2020 7:34 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0035FF8FEB5F-0708203490
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Tool post moved and tool offsets
Marty,
No I had the feed set to high. I also don't have RPM input on my lathe. Thanks that is what I thought.
No I had the feed set to high. I also don't have RPM input on my lathe. Thanks that is what I thought.