I got the Franco Lathe post processor working on Fusion 360 but when I post the program the g-code is in radius while my Acorn is looking for a diameter. Is there any way to change to diameter mode in the post processor or is there a work around?
Thanks
Franco Lathe Post Processor Question?? (Resolved)
Moderator: cnckeith
-
GBCues
- Posts: 111
- Joined: Tue Aug 14, 2018 10:49 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: noneC120192
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: Denver, CO
Re: Franco Lathe Post Processor Question??
Hmmm . . I use Franco's lathe post processer on my Acorn in lathe and I get diameter mode.
You'll probably need to post a Report and your G-code program for the experts here to look at.
You'll probably need to post a Report and your G-code program for the experts here to look at.
-
vw_chuck
- Posts: 194
- Joined: Sun Sep 20, 2020 7:34 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0035FF8FEB5F-0708203490
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Franco Lathe Post Processor Question??
Yes it seems to be working now on my machine. Not sure what was going on. May have been my old eyes reading the wrong numbers