Have new acorn board and I cannot get axis to home. End up with "313
Waiting for dwell time (M26)". I have limit switches configured on Input 1
as "all limits". It just sets all DROs at zeros but does not move any axis.
Homing difficulties
Moderator: cnckeith
-
- Posts: 2
- Joined: Sat Jun 27, 2020 11:37 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0035FF8A2DAA-0610203411
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Homing difficulties
- Attachments
-
- report_0035FF8A2DAA-0610203411_2020-06-29_08-24-37.zip
- (588.74 KiB) Downloaded 79 times
-
- Posts: 9914
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: Homing difficulties
It is because you set LIMITs not HOME LIMITS
From your report: In the INPUT Definitions Tab Choose HOME LIMIT from the drop down and set inputs 1,2,3 to: That should take care of it
Marty
From your report: In the INPUT Definitions Tab Choose HOME LIMIT from the drop down and set inputs 1,2,3 to: That should take care of it
Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ