Wireless MPG Setup

DrDave · Post by **DrDave** » Sat Jun 27, 2020 6:48 am

Hi,
I have just tried to install my MPG-4 on my computer, but I fell at Step4. When I open cncWizard, I do not have tab 4 as "Control Peripherals". All I have is:
1 - Primary System Configuration
2 - Axis Configuration
3 - Spindle Setup
4 - Advanced Axis Configuration
5 - DB25 Signal Mapping

I have tried installing the USB receiver in different USB ports and rebooting the PC (and Acorn), but cannot get the desired Tab. What might I be doing wrong?
Regards
Dave

Post by **martyscncgarage** » Sat Jun 27, 2020 11:19 am

Problem is you are running CNC12 4.10, not been supported for some time.
You need to upgrade to 4.50

Instructions:
viewtopic.php?f=60&t=4457

DrDave · Post by **DrDave** » Sat Jun 27, 2020 4:13 pm

That was it. Upgraded to 4.50 (with some huffin' & puffin') & the MPG is working now.
Thank you

Post by **martyscncgarage** » Sat Jun 27, 2020 4:23 pm

DrDave wrote: ↑Sat Jun 27, 2020 4:13 pm That was it. Upgraded to 4.50 (with some huffin' & puffin') & the MPG is working now.
Thank you

It's a little different. The Wizard as you found is now in the Utilities menu. Glad you got upgraded ok.
Enjoy!
Marty

Centroid Community CNC Support Forum

Wireless MPG Setup

Wireless MPG Setup

Re: Wireless MPG Setup

Re: Wireless MPG Setup

Re: Wireless MPG Setup