Umbrella ATC Guidance
Moderator: cnckeith
-
- Posts: 2190
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
Re: Umbrella ATC Guidance
I've done a number of rotary carousels. Drive them with a stepper & gearbox
-
- Posts: 181
- Joined: Thu May 17, 2018 8:19 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: Umbrella ATC Guidance
I have done an ATC both ways, using the A Axis & stepper is by far the easiest.
Converted to Ether1616 control to allow use of A-Axis for future use. Both setups listed below with macros attached.
A-Axis
viewtopic.php?f=60&t=3172
Ether1616
viewtopic.php?f=60&t=3900&p=34421#p34421
This is by no means a definitive guide, both Marty & Gary have way more experience than me.
Regards,
Michael
Converted to Ether1616 control to allow use of A-Axis for future use. Both setups listed below with macros attached.
A-Axis
viewtopic.php?f=60&t=3172
Ether1616
viewtopic.php?f=60&t=3900&p=34421#p34421
This is by no means a definitive guide, both Marty & Gary have way more experience than me.
Regards,
Michael