Using a DMM 750 watt servo motor as a spindle motor

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
Dbur525
Posts: 119
Joined: Fri Dec 22, 2017 8:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: No
CPU10 or CPU7: No

Using a DMM 750 watt servo motor as a spindle motor

Post by Dbur525 »

Well, seems i cannot use the DMM auto tune on the spindle motor. Im about to email DMM support and asked for basic motor settings.
but if anybody is using this motor as a spindle with success, i would love to see your motor settings.
My spindle does run, but in aluminum with a 1.5 inch 3 flute facing mill i can only take .030 depth of cut 8 inches per minute any deeper or faster feed than that and motor just stalls and trips spindle fault alarm (lack of (torque)
Post Reply