Well, seems i cannot use the DMM auto tune on the spindle motor. Im about to email DMM support and asked for basic motor settings.
but if anybody is using this motor as a spindle with success, i would love to see your motor settings.
My spindle does run, but in aluminum with a 1.5 inch 3 flute facing mill i can only take .030 depth of cut 8 inches per minute any deeper or faster feed than that and motor just stalls and trips spindle fault alarm (lack of (torque)
Using a DMM 750 watt servo motor as a spindle motor
Moderator: cnckeith
-
- Posts: 119
- Joined: Fri Dec 22, 2017 8:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Using a DMM 750 watt servo motor as a spindle motor
(Note: Liking will "up vote" a post in the search results helping others find good information faster)