Can anyone please advise the maximum feed rate settings X,Y and Z for a post processor on my machine which is basically a bridgeport size knee mill.
I am also wanting to set up an A rotary axis at some point in the near future which will be powered by a 400w AC Servo same rpm ratings and this will be set up at a 1:7 ratio from motor pulley to spindle.
Max spindle speed is 4200 rpm. My old system was I believe set up as max 800mm and 2540mm in rapid mode running DC servo motors.
I am running DMM AC Servos 750w rated speed is 3000 rpm , max 5000rpm They are set up at 1:3 ratio from motor pulley to ballscrew pulley.
This is basically setting up the post processor and afterwards, I will set up all feed rates within my alphacam software.
Maybe somebody has settings on their knee type machine running acorn and can assist me?
Any help much appreciated,
TIA
FEED RATES
Moderator: cnckeith
-
- Posts: 3102
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: FEED RATES
I set the maximum feed rates in the post to the same values as the max settings on the mill.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
-
- Posts: 44
- Joined: Wed Oct 16, 2019 9:09 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: Yes
- Location: SPAIN
Re: FEED RATES
Thanks Tom,
I checked on my machine manual and have sorted now. 2540mm rapid and max feed rate at 1500mm per minute
I checked on my machine manual and have sorted now. 2540mm rapid and max feed rate at 1500mm per minute