Hello is it possible to program a tool touch off probe like this one:
to perform the "Smart Tool Touch-off" in the Legacy cnc video?
Thank you.
Tool touch off
Moderator: cnckeith
-
ShawnM
- Posts: 2234
- Joined: Fri May 24, 2019 8:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734C6498-0401191832
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Clearwater, FL
Re: Tool touch off
Absolutely, my setup does exactly what you see in the video. There are lots of posts on the forum about the tool change macro.
Read this topic:
viewtopic.php?f=63&t=1493&hilit=tool+macros
Read this topic:
viewtopic.php?f=63&t=1493&hilit=tool+macros
-
tuffduck
- Posts: 359
- Joined: Mon Mar 02, 2020 5:07 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Scotland, ON, Canada
Re: Tool touch off
Thanks, I will have a look.