download todays build , link is at bottom of first post in this thread.
viewtopic.php?f=60&t=4231
Question about hooking up KP-3 probe
Moderator: cnckeith
-
- Posts: 7334
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Question about hooking up KP-3 probe
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
-
- Posts: 6
- Joined: Mon Dec 23, 2019 3:57 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn-2541
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Question about hooking up KP-3 probe
Great, thanks! Looking at the release notes it had something to do with a tool touch off being selected at the same time? That’s odd because I don’t have a tool touch off device connected so if that’s the case I must have accidentally selected something.cnckeith wrote: ↑Thu May 14, 2020 1:51 pm download todays build , link is at bottom of first post in this thread.
viewtopic.php?f=60&t=4231
I’ll give it a go tonight, thanks again!