I have a lathe, and I find the keyboard arrow keys not at all intuative.
I cant seem to find anything in the Wizard to do this.
Can I change the assignment of the keys for example:
Left Arrow to Z-
Right Arrow to Z+
Up arrow to X-
Down Arrow to X+
Rob
Sydney, Australia
Keyboard Jog Key Assignment
Moderator: cnckeith
-
- Posts: 41
- Joined: Mon Dec 09, 2019 5:44 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: F8369BFEC0B2-1030192596
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Sydney, Australia
- Contact:
-
- Posts: 3151
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: Keyboard Jog Key Assignment
In just a short while you will be able to do that. It is being beta tested now and will be out with the next release. Soon, the Virtual Control Panel will be fully customizable!
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Re: Keyboard Jog Key Assignment
If you are talking about the keyboard jogging (and not the virtual control panel) then it should already be as you describe, except that you apparently have front-mounted tools (X+ down), so you should set Parameter 1 = 3.
If that doesn't work, then post a Report so we can see what is missing from your PLC program.
If that doesn't work, then post a Report so we can see what is missing from your PLC program.