Thanks Marty, I'm starting to think also the moral of this story is to buy supported equipment like you said. Hopefully we can find someone who has had luck programming no name drives though...
If not, Instead of buying new drives I think ill try to coax all the signals into an Arduino to speak to the acorn board.
HBS57 Drivers
Moderator: cnckeith
-
- Posts: 346
- Joined: Thu Nov 23, 2017 1:39 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: HBS57 Drivers
Have you contacted Fasttobuy? I have found them to be very responsive and knowledgeable. Go to their website and contact them directly.
-
- Posts: 17
- Joined: Thu Aug 09, 2018 9:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: HBS57 Drivers
program from StepperOnline might do it, HBSEXT is the one i use. https://www.omc-stepperonline.com/downl ... _setup.zip