ACORN DB25 Connections <answered>

[JoeG]

Does any one know what the current limit is for the DB25 outputs?

I can not find any published information on these. (or the ones on the screw terminals either)

I have some SSRs that draw ~10ma and for keeping things clean I want to use the connections on the DB25 connector. I used an old parallel printer cable to make a flying lead cable, it kept the wiring to my DMM DYN2 servo amplifiers very clean.

Can someone point me to a document where this information is listed?

Thanks,

JoeG

[Gary Campbell]

Try this... Should be in your docs download

centroid_acorn_spec_manual.pdf

(1.01 MiB) Downloaded 117 times

[cnckeith]

http://www.centroidcnc.com/centroid_diy ... manual.pdf

[JoeG]

Thanks guys, I released after the fact that I did not post this in the acorn section.

Thanks for the links.

JoeG