Chinese hsd spindle

[martyscncgarage]

I would recommend dry contact relay outputs.

Founded this, ali baba,
Is this suitable,

Instead of providing screenshots, provide links.....
PIcture doesn't do much good without being able to read the specs/info

[Rosmadi]

I would recommend dry contact relay outputs.

Founded this, ali baba,
Is this suitable,

Instead of providing screenshots, provide links.....
PIcture doesn't do much good without being able to read the specs/info

Here

https://m.alibaba.com/product/606273081 ... hare%22%7D

[martyscncgarage]

Looks right because it shows the inputs with a negative number but you'd better contact them to make sure its NPN

[Rosmadi]

Looks right because it shows the inputs with a negative number but you'd better contact them to make sure its NPN

Thanks marty,, contact has been made, NPN is confirmed,

[Rosmadi]

Hi marty, got the relay board,, which schematic should i follow

[martyscncgarage]

Do you have basic electrical/electronic skills?
Very important to be successful and to be able to work your way through the conversion.
Use the Generic VFD wiring as a guide.

You will connect 24VDC from Acorn logic power supply to the COM terminal of that relay board.
You have 8 relays. The older revision Acorn board has two relays on it.
You will take Outputs 3-8 on Acorn to Inputs 3-8 on the relay board.


Marty

[Rosmadi]

Do you have basic electrical/electronic skills?
Very important to be successful and to be able to work your way through the conversion.
Use the Generic VFD wiring as a guide.

You will connect 24VDC from Acorn logic power supply to the COM terminal of that relay board.
You have 8 relays. The older revision Acorn board has two relays on it.
You will take Outputs 3-8 on Acorn to Inputs 3-8 on the relay board.


Marty

ok, i guess i have to try it outn

[Rosmadi]

Hi, my output 4 for spindle foward is seem not respone,, can i use output 3 for spindle foward, and how to repair output4 if is damage,, i think i use those ouput4 to power some relay at the first place ,, maybe i made a wrong connection,,

[martyscncgarage]

Hi, my output 4 for spindle foward is seem not respone,, can i use output 3 for spindle foward, and how to repair output4 if is damage,, i think i use those ouput4 to power some relay at the first place ,, maybe i made a wrong connection,,

ALWAYS post a fresh report when asking for help Rosmadi.
Please post pictures of how you wired up the relay.
Post a screen shot of your Wizard input and output screens.

You need to make sure you wired that relay board correctly FIRST.

[Rosmadi]

sorry, here myreport. picture is on the way.. i have use my phone to post it,,is easy that way