Page 1 of 1
Dolphin CAD/CAM post processor
Posted: Sun Aug 26, 2018 7:57 pm
by n2xd
Is there anyone using Dolphin CAD/CAM for Acorn milling? If so could you point me to a working Post Processor. Thanks.
John
Re: Dolphin CAD/CAM post processor
Posted: Mon Aug 27, 2018 9:49 am
by martyscncgarage
n2xd wrote: ↑Sun Aug 26, 2018 7:57 pm
Is there anyone using Dolphin CAD/CAM for Acorn milling? If so could you point me to a working Post Processor. Thanks.
John
Is there not a post processor for CENTROID?
Re: Dolphin CAD/CAM post processor
Posted: Mon Aug 27, 2018 11:22 am
by deanq
John,
This is one I wrote for my Bridgeport. Dolphin support is pretty much non-existent now. This is what I use for version 14 (most current version). the PP that is provided for Centroid is for some kind of manual VMC abortion. Use this at your own risk. verify it does what you want it to, before relying on it.
This works for ME!. YMMV! replace the .doc extension with .ppr and add it to your pp folder.
Re: Dolphin CAD/CAM post processor
Posted: Tue Aug 28, 2018 8:42 am
by n2xd
Thanks for the file I will give it a look over. At least it will give me a starting point. Again Thank You very Much.
John