On my lathe conversion using an Acorn board i need to use a 2 wire sensor (It’s a specific size and shape to fit in the lathe tool turret) and I cant find a 3 wire alternative. The manual says to not use a 2 wire sensor. Can anyone advise if a 2 wire will in fact work or a solution.
Re: 2 wire proximity sensor
Posted: Sun Nov 24, 2024 2:24 pm
by Gary Campbell
Post the data sheet for the component
Re: 2 wire proximity sensor
Posted: Mon Nov 25, 2024 4:31 am
by Stew260
With sensor data sheets.
Re: 2 wire proximity sensor
Posted: Mon Nov 25, 2024 7:12 am
by robtown
I have no idea if this will work for you or not.
Re: 2 wire proximity sensor
Posted: Mon Nov 25, 2024 11:24 am
by Stew260
Many thanks. I did look at that video and think that it may still upset the acorn due to the voltage drop but will research this again to make sure.
