Teknic Merdian Controllers

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

TeknicTom
Posts: 1
Joined: Wed Oct 18, 2017 4:01 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: No
CPU10 or CPU7: No

Re: Teknic Merdian Controllers

Post by TeknicTom »

Hi vinnito1, I am an engineer at Teknic and your post was forwarded to me for review. Teknic's Meridian is a point to point integrated servo drive and controller that would not be appropriate for CNC type applications. In addition, the Meridian is not compatible with the Centroid Acorn because they are both controllers.

As mentioned in previous posts, the Acorn works well (and is a cost effective solution) when combined with the ClearPath SD (step and direction) motors. In case you are interested, here is a link to the ClearPath SD page:

https://www.teknic.com/products/clearpa ... eplacement

Good luck and best regards,

Tom T
frijoli
Posts: 595
Joined: Tue Sep 12, 2017 10:03 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: 1030090099
DC3IOB: Yes
CNC12: Yes
CNC11: Yes
CPU10 or CPU7: No
Location: Outside Winston-Salem, NC
Contact:

Re: Teknic Merdian Controllers

Post by frijoli »

TeknicTom wrote: Wed Oct 18, 2017 4:13 pm Hi vinnito1, I am an engineer at Teknic and your post was forwarded to me for review.

Good luck and best regards,

Tom T
Hey Tom, you should keep hanging around here!!!
Clay
near Winston-Salem, NC
unofficial ACORN fb group https://www.facebook.com/groups/897054597120437/
Post Reply