I am preparing to setup CHIPS on my router and I am thinking there must be a standard image I can use for the VCP button. Are the users generating their own or is there a standard SVG image available?
thank you
Jr
CHIPS
Moderator: cnckeith
-
Jrlee
- Posts: 56
- Joined: Wed Jan 09, 2019 1:59 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: F045DA798AE4-1119181352
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Contact:
CHIPS
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Nigelo
- Posts: 398
- Joined: Tue Dec 11, 2018 4:03 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: F045DA80C8B8-0905181172
E415F6F70BC3-0318203049
98F07B91FC6B-0123236802 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: UK East Coast
Re: CHIPS
The CHIPS icon is automatically installed with the CHIPS app. You will also be guided with the exact position on the VCP where you want it placed
Suggest you follow Swissi's detailed Instructions on this Forum where all of this is covered
Suggest you follow Swissi's detailed Instructions on this Forum where all of this is covered
Hope this helps
Nigel
"You can lead a horse to water but you cannot force it to drink"
Nigel
"You can lead a horse to water but you cannot force it to drink"
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Jrlee
- Posts: 56
- Joined: Wed Jan 09, 2019 1:59 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: F045DA798AE4-1119181352
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Contact:
Re: CHIPS
Nigelo thank you for your response. So I repeated the start of the install of CHIPS a little while ago and when I got to the point of selecting the location for the new CHIPS button CNC12 went away as before. But this time I moved document away that remained on the display screen and found the VCP panel that I was to select the location for the new button. I should be able to finish tomorrow I hope.
Thank you again
Jr
Thank you again
Jr
(Note: Liking will "up vote" a post in the search results helping others find good information faster)