Re: Teknic Merdian Controllers
Posted: Wed Oct 18, 2017 4:13 pm
Hi vinnito1, I am an engineer at Teknic and your post was forwarded to me for review. Teknic's Meridian is a point to point integrated servo drive and controller that would not be appropriate for CNC type applications. In addition, the Meridian is not compatible with the Centroid Acorn because they are both controllers.
As mentioned in previous posts, the Acorn works well (and is a cost effective solution) when combined with the ClearPath SD (step and direction) motors. In case you are interested, here is a link to the ClearPath SD page:
https://www.teknic.com/products/clearpa ... eplacement
Good luck and best regards,
Tom T
As mentioned in previous posts, the Acorn works well (and is a cost effective solution) when combined with the ClearPath SD (step and direction) motors. In case you are interested, here is a link to the ClearPath SD page:
https://www.teknic.com/products/clearpa ... eplacement
Good luck and best regards,
Tom T