Acorn Geckodrive g320x

[cnckeith]

ok, now we are at a good baseline.

the disk images show that this is classic Lost Motion.

with the machine off

put your hand on the screw

turn the screw 1/8th - 1/4 of a turn CW then CCW, back and forth.

you will feel the 'lost motion' you will be able to rotate the screw for a number of degrees that will result in NO motion on the table.

perform this test.

[JosephPulido]

Hello friend I already performed this test and there is no loss of movement on the table, please watch the video I uploaded below.

[suntravel]

Measuring backlash:

viewtopic.php?f=63&t=5404&p=46199&hilit ... ash#p46199

Uwe

[JosephPulido]

I've already done the backslash adjustment once and it was a very small 0.02mm fit. When I do the one-way motion test, for example on X or Y, it moves perfectly when it goes in direction + or - the needle of the dial comparator is in the same position. But when I make a circle it comes out deformed.

[cnckeith]

loose motor or screw pulley?

loose Motor encoder?

drive not working with encoder feedback?

[cnckeith]

post the g code program you are using for the images!

[JosephPulido]

The screw is not loose the pulley of the motor is well secured I did the test you told me, and the movement is perfect please The screw is not loose, the pulley of the motor is well secured, I did the test you told me, and the movement is perfect, please see the video I uploaded to YouTube

[JosephPulido]

I don't understand what you want to tell me??



drive not working with encoder feedback?

[JosephPulido]

Friend please watch this video, my machine is perfect in its movement in all its axes but the circles continue to come out deformed, please watch the video that I uploaded to YouTube carefully, here I place the link watch this video.

https://youtube.com/shorts/60BtwWWOlFQ? ... gEt1GS4hLv

[JosephPulido]

Please also watch this video


https://youtube.com/shorts/hHmBDvEgkGc? ... rlynVpqaZC