AB 525
Moderator: cnckeith
-
- Posts: 4
- Joined: Sun Nov 05, 2023 6:21 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
AB 525
An AB Powerflex 525 just came up in the classifieds today for $200 New in box.Time may be short to do research,anyone else using this drive? Would it be a good selection to change over my 10 hp manual lathe to cnc?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
- Posts: 705
- Joined: Sun Sep 16, 2018 9:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: South Jordan, UT
Re: AB 525
What size motors can that AB 525 handle? The drive I'm looking at online has an output capacity of 2.5A, which is about 0.4 hp. You wrote that your manual lathe has a 10 hp motor.
-Mike Richards
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
- Posts: 4
- Joined: Sun Nov 05, 2023 6:21 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: AB 525
Its rated for 15hp
(Note: Liking will "up vote" a post in the search results helping others find good information faster)