Chaining GCode File

[Gerral]

At the completion of a job I'd like it to load the no_job_loaded.cnc file automatically.

I've not found any documentation to accomplish this in the GCode file itself. Is this actually possible?

Thanks in advance.

[Chaz]

Oddly some of Uwe's vids popped up on my feed.

at 27 secs you can see G65 filename. Would that not work?

[cncsnw]

From the "Configuration" chapter of the Centroid operator's manual:

15.4.206 Parameter 401 – Forget Last Job Loaded
Setting this parameter to a value of 1.0 will cause the last job loaded to be forgotten and replaced with the name
“no_job_loaded.cnc” when the CNC software is started.