2 wire proximity sensor

[Stew260]

On my lathe conversion using an Acorn board i need to use a 2 wire sensor (It’s a specific size and shape to fit in the lathe tool turret) and I cant find a 3 wire alternative. The manual says to not use a 2 wire sensor. Can anyone advise if a 2 wire will in fact work or a solution.

[Gary Campbell]

Post the data sheet for the component

[Stew260]

With sensor data sheets.

[robtown]

I have no idea if this will work for you or not.

[Stew260]

Many thanks. I did look at that video and think that it may still upset the acorn due to the voltage drop but will research this again to make sure.

[Stew260]

Now sorted. Thanks