Axis drive type for Stepperonline DM542T
Moderator: cnckeith
-
Lincolncentroid
- Posts: 1
- Joined: Mon Sep 16, 2024 4:44 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Axis drive type for Stepperonline DM542T
Can someone advise me on. which drive I should select in the Wizard for a Stepperonline DM542T? The attachment shows the selections but no of them is obviously the one I want. Thanks in advance for your help.
- Attachments
-
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Gary Campbell
- Posts: 2294
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
Re: Axis drive type for Stepperonline DM542T
LeadShine DM series
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
suntravel
- Posts: 2551
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: Axis drive type for Stepperonline DM542T
This is only a pre configuration you can choose DM Series and configure in the next steps according to your drivers, but to be honest, I would not use open loop steppers.
Uwe
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)