G01 not working on Lathe
Moderator: cnckeith
-
Measurement10
- Posts: 76
- Joined: Wed Oct 13, 2021 11:58 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
G01 not working on Lathe
I normally use G01 to move an axis at a specific feedrate when dialing in tools, always worked on the Mill. After moving to lathe i notice it doesn't work. Axis will not move. Can someone fill me in as to why? New to all this...
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
vw_chuck
- Posts: 201
- Joined: Sun Sep 20, 2020 7:34 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0035FF8FEB5F-0708203490
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: G01 not working on Lathe
You have to take it out of feed per rev mode and put into feed per inch. G98 is feed per minute. G99 is feed per revolution.
It is waiting to see a RPM signal to start moving but there isn't one.
It is waiting to see a RPM signal to start moving but there isn't one.
1 user liked this post
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
(Note: Liking will "up vote" a post in the search results helping others find good information faster)