The Centroid CNC PC Tuner v1.3.0 has been released.

[johannes]

For me as well, the 1.0.3 PC tuner crashes when testing CPU speed. Yes, it has internet connection, and the same computer tested fine with previous PC tuner version.
The fact that the installer is not signed (and therefore causing Windows to flag it as malware) is not really making me comfortable, considering you give it full administrator access to modify your computer, install any software or driver, and it has internet access...

[cnckeith]

For me as well, the 1.0.3 PC tuner crashes when testing CPU speed. Yes, it has internet connection, and the same computer tested fine with previous PC tuner version.
The fact that the installer is not signed (and therefore causing Windows to flag it as malware) is not really making me comfortable, considering you give it full administrator access to modify your computer, install any software or driver, and it has internet access...

thanks for the feedback.

any more info you can provide would be helpful, info on your PC etc.
and fyi. you don't need an internet connection to run the PC tuner.
maybe we could Teamviewer into the PC with you to see the crash?

[ShawnM]

I ran this last week on a PC that I'm setting up for AcornSix and it told me the hard drive was not a SSD and it is. Everything else worked as it should.

[Marik]

I got a new computer--HP 23.8 All in One PC 24-cb1124. After running this app 'Restore Point' the computer tried to restart and stuck at the first page with HP logo and didn't do anything. I waited for about an hour, but nothing was happening. I restarted again and had to go to entire process of system recover.

Best, M