I am considering using the Centroid Wired MPG (PN 11069) with a Galil motion controller to jog an X-Y stage in an SEM chamber. I have used this MPG with an Oak controller in the past and like it.
But I could not find a manual or wiring diagram showing how the encoder and the switches are pinned out.
Can somebody please point me to the appropriate document?
Wired MPG pinout
Moderator: cnckeith
Re: Wired MPG pinout
A pinout for the 28-pin connector is attached.
The wire noted wire colors are for the MPG coil cord (or they were when I first drew this; I have not verified it in recent years to see if production changed).
I believe the DC Common (WHT wire, pin 22) is used as the common for the two selector switches.
The wire noted wire colors are for the MPG coil cord (or they were when I first drew this; I have not verified it in recent years to see if production changed).
I believe the DC Common (WHT wire, pin 22) is used as the common for the two selector switches.
- Attachments
-
- MPG28PinConMPU11.pdf
- (23.34 KiB) Downloaded 23 times
-
simmonds
- Posts: 40
- Joined: Thu Aug 04, 2011 4:15 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: A900196
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Wired MPG pinout
Thanks for the information. Sorry for the late response.