Centroid post processor for Fusion360 question

[midy]

Can someone please tell me how to change the PP from rear to front toolpost?

[tblough]

Shouldn't make a difference. The g-code should be identical.

[suntravel]

Generic turning post for Centroid. Use Turret 0 for Positional Turret, Turret 101 for QCTP on X- Post, Turret 102 for QCTP on X+ Post, Turret 103 for Gang Tooling on X- Post, Turret 104 for Gang Tooling on X+ Tool Post.

Uwe

[midy]

Thanks Uwe, I can't find where in the post you make this change, indeed if it is in the post?

[suntravel]

You are asked for the turret in the tool setup in fusion where you also set the tool number.

Uwe

[midy]

ahhhh, thanks Uwe