U tube videos by centroid

midy · Post by **midy** » Wed May 10, 2023 1:11 pm

Please keep the videos coming keith. Could you do a more in depth one on measuring ALL types of tools with an auto tool touch off compared to manual. I've read the manual but still feel like i'm missing something, a moving picture speaks a million words!

CNCMaryland · Post by **CNCMaryland** » Wed May 10, 2023 1:40 pm

Have you seen this one?

Post by **cnckeith** » Wed May 10, 2023 3:01 pm

thanks, i wish that is all i had to do is create videos, love doing it every chance i get in between juggling chainsaws.

midy · Post by **midy** » Thu May 11, 2023 5:41 am

Sorry, should have been more specific, I missed out a very important detail. The word lathe!

Post by **cnckeith** » Thu May 11, 2023 4:20 pm

midy wrote: ↑Thu May 11, 2023 5:41 am Sorry, should have been more specific, I missed out a very important detail. The word lathe!

yeah for sure.. hopefully someone else will step up the plate, just don't have time to tackle that project at the moment, the operator manual does a pretty good job in this regard, i have a lathe tool primer video up that shows typical od tool setup, once you get that its not hard to follow the manual setup instructions for drills and id tools

midy · Post by **midy** » Wed May 24, 2023 12:03 pm

Regarding the operator manual, could somebody at centroid take a look at the ID tools setting instruction pages? It seems to me to go from ID tools and back to OD, almost as if a page is missing? And 1 page (71) looks like a repeat?

midy · Post by **midy** » Fri May 26, 2023 6:13 am

cncjenna · Post by **cncjenna** » Tue May 30, 2023 3:20 pm

midy wrote: ↑Wed May 24, 2023 12:03 pm Regarding the operator manual, could somebody at centroid take a look at the ID tools setting instruction pages? It seems to me to go from ID tools and back to OD, almost as if a page is missing? And 1 page (71) looks like a repeat?

Hi there, you are completely right about these pages. They will be fixed with our next draft. Thank you for the heads up!

midy · Post by **midy** » Sun Jun 04, 2023 11:58 am

This is why I have been struggling with setting ID tools, when asking for help have mostly been told to read the manual and the manual is wrong!

Post by **cnckeith** » Mon Jun 05, 2023 2:09 pm

midy wrote: ↑Sun Jun 04, 2023 11:58 am This is why I have been struggling with setting ID tools, when asking for help have mostly been told to read the manual and the manual is wrong!

thanks, in the mean time the v4.20 manual lathe tool setup section is 'correct'

www.centroidcnc.com/centroid_diy/downlo ... -v4.20.pdf

Centroid Community CNC Support Forum

U tube videos by centroid

U tube videos by centroid

Re: U tube videos by centroid

Re: U tube videos by centroid

Re: U tube videos by centroid

Re: U tube videos by centroid

Re: U tube videos by centroid

Re: U tube videos by centroid

Re: U tube videos by centroid

Re: U tube videos by centroid

Re: U tube videos by centroid