Parameter for relief on turn cycle

Scary · Post by **Scary** » Tue Jul 05, 2022 4:00 am

Hi all, does anyone know what parameter changes the amount of tool retract on a simple "turn" cycle in intercon. Profile is working fine but I am chasing a little more relief on the turn cycle to allow me to unhook chips sometimes. None of the parameters i have found so fad seem to affect it

suntravel · Post by **suntravel** » Tue Jul 05, 2022 5:24 am

Clearance Amount in ICN Setup page.

Uwe

Scary · Post by **Scary** » Tue Jul 05, 2022 6:24 am

I have tried that setting but it doesn’t seem to change it any. The profile settings change behaviour but the clearance setting doesn’t behave any differently if you change the numbers. Strange…….

suntravel · Post by **suntravel** » Tue Jul 05, 2022 6:40 am

Scary wrote: ↑Tue Jul 05, 2022 6:24 am I have tried that setting but it doesn’t seem to change it any. The profile settings change behaviour but the clearance setting doesn’t behave any differently if you change the numbers. Strange…….

ok I just tested that Turn in Intercon produces G90 cycles.

They just return to the start position, so there is no escape amount.

Uwe

Scary · Post by **Scary** » Tue Jul 05, 2022 7:02 am

That sucks! Oh well, back to using profile for everything. At least you can chamfer/radius corners in profile

suntravel · Post by **suntravel** » Tue Jul 05, 2022 7:08 am

Profile is better anyway, especial if you have finish amount in Z

Uwe

Centroid Community CNC Support Forum

Parameter for relief on turn cycle

Parameter for relief on turn cycle

Re: Parameter for relief on turn cycle

Re: Parameter for relief on turn cycle

Re: Parameter for relief on turn cycle

Re: Parameter for relief on turn cycle

Re: Parameter for relief on turn cycle