Intercon for lathe training video?
Moderator: cnckeith
-
- Posts: 536
- Joined: Sat Jul 08, 2017 7:38 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: n/a yet
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: Collierville, TN USA
Intercon for lathe training video?
I haven't been able to find one (other than a in foreign language) and was hoping someone knows of one. Is there one on the Centroid website & I just overlooked it?
Milton in Collierville, TN
"Accuracy is the sum total of your compensating mistakes."
"Accuracy is the sum total of your compensating mistakes."
-
- Posts: 7554
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Intercon for lathe training video?
Marty is going to make a fresh one using his Acorn equipped Emco 120.
In the meantime the lathe operator manual has step-by-step tutorials for intercon check them out also the section on setting up tool offsets is pretty good and steps you through that as well
In the meantime the lathe operator manual has step-by-step tutorials for intercon check them out also the section on setting up tool offsets is pretty good and steps you through that as well
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
-
- Posts: 536
- Joined: Sat Jul 08, 2017 7:38 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: n/a yet
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: Collierville, TN USA
Re: Intercon for lathe training video?
For anyone else that is trying to learn Intercon for a lathe, this video by Keith's younger brother Keith does a great job in this training video for mill Intercon. It cleared up most all of my befuddlement!
http://www.centroidcnc.com/cncvideo/vid ... step4.html
http://www.centroidcnc.com/cncvideo/vid ... step4.html
Milton in Collierville, TN
"Accuracy is the sum total of your compensating mistakes."
"Accuracy is the sum total of your compensating mistakes."