List of error codes?

[specnaz]

Hey guys, finally back off work, so I tried MDI and it immediately cancels the job and throws Axis3 error 9027 , as someone said possible and enable issue, how do I fix this, what am I looking for? Thanks

[martyscncgarage]

Hey guys, finally back off work, so I tried MDI and it immediately cancels the job and throws Axis3 error 9027 , as someone said possible and enable issue, how do I fix this, what am I looking for? Thanks

Stick with one thread no need to start a new one.
Follow this post: viewtopic.php?f=60&t=1043
ALWAYS POST A FRESH REPORT.

We have no idea what you are working with, what kind of machine etc We can't "SEE" what you "SEE". Provide good thorough information and we might be able to make better suggestions to help you.

Marty

[specnaz]

I did put the report last time, nothing has changed since, error is the same and i have no replies, how am i supposed get help about this?

[specnaz]

sorry for the delay, here's my report.zip attached , i rewired all the connectors with ferules , verified all is well connected and in, then I ran another auto-tune routine on the Clearpath CPM-SDSK-2321S-EQN for my Z axis through USB port on it, reported no issues. Then in CNC12 config I made sure it travels in the right direction, and usually it works, but everytime I try to move Y axis and then very shortly afterwards I try to move Z it throws quick 9027 error, motors turn green right away but i have to hit cycle start to be able to jog. I'm not sure whats going on , Z axis travels very smoothly

Marty garage, ive posted it here, nothing has been touched or changed since