Hardware help e-stop contactor and fuse blocks

RaptorMachine · Post by **RaptorMachine** » Mon Jan 20, 2020 4:56 pm

Hey Guys,

finally getting my acorn up and running.. can you recommend me a fuse block ( will be running 3 axis possibly 4 axis dyn4 220 VAC motors ) and an E stop contactor?

and where do you get your wire raceway ? maybe 1 x 1

thanks !
Joe

slodat · Post by **slodat** » Mon Jan 20, 2020 5:42 pm

Automation direct is a great source for this stuff.

Post by **martyscncgarage** » Tue Jan 21, 2020 3:00 pm

slodat wrote: ↑Mon Jan 20, 2020 5:42 pm Automation direct is a great source for this stuff.

Ditto on Automation Direct.

BASE · Post by **BASE** » Tue Jan 21, 2020 4:45 pm

I think the only thing I didn't buy from Automation Direct was the e-stop, I got that from Centroid. They also sell a really neat strain relief for routing the cables out of the cabinet. https://www.centroidcnc.com/centroid_di ... nents.html

RaptorMachine · Post by **RaptorMachine** » Thu Jan 23, 2020 8:19 pm

thank you gentlemen !! i will check it out

Centroid Community CNC Support Forum

Hardware help e-stop contactor and fuse blocks

Hardware help e-stop contactor and fuse blocks

Re: Hardware help e-stop contactor and fuse blocks

Re: Hardware help e-stop contactor and fuse blocks

Re: Hardware help e-stop contactor and fuse blocks

Re: Hardware help e-stop contactor and fuse blocks