RF-30 Mill/Drill: Acorn Enclosure and connection to existing hardware
Posted: Wed Aug 23, 2017 7:10 pm
I have been very fortunate to be able to unplug my DB25 cable from my old PC running Mach3 and plug it into the Acorn board. Not much more to the story although I do include a link describing my existing hardware including stepper drivers, eStop circuit, and various improvements to the RF-30 so it would operate well with the original lead screws.
Most of this article deals with the enclosure I built for the Acorn board and its power supply. As I continue this journey, more articles will be offered.
If you are interested, see http://rick.sparber.org/CAHE.pdf
Rick
Most of this article deals with the enclosure I built for the Acorn board and its power supply. As I continue this journey, more articles will be offered.
If you are interested, see http://rick.sparber.org/CAHE.pdf
Rick