Clearpath 48x48 router close to finalized. Custom built electronics enclosure
Posted: Mon Oct 31, 2022 4:54 pm
After finding the pre built router on marketplace for a deal to good to pass up, I was launched into the world of centroid.
The router itself was completely built, all the rails had already been aligned, you could blow on the gantry and move it. The wiring however was a disaster. Profession is Aircraft wiring so I had to blow this part out of the box.
components as follows:
Centroid ACORN
Centroid Either1616
CNC4pc C86ACCP
(CNC S30S On order)
ABB ACS VFD
I just finished the vacuum table consisting of a 10hp Regen Blower at 575CFM at 18"Hg across the entire 4x4 table I can place a 6"x6" plate anywhere and need a wedge to remove it. Currently I have not had a single sheet come loose to date.
I would love to hear some feed back!
The router itself was completely built, all the rails had already been aligned, you could blow on the gantry and move it. The wiring however was a disaster. Profession is Aircraft wiring so I had to blow this part out of the box.
components as follows:
Centroid ACORN
Centroid Either1616
CNC4pc C86ACCP
(CNC S30S On order)
ABB ACS VFD
I just finished the vacuum table consisting of a 10hp Regen Blower at 575CFM at 18"Hg across the entire 4x4 table I can place a 6"x6" plate anywhere and need a wedge to remove it. Currently I have not had a single sheet come loose to date.
I would love to hear some feed back!