Videos on CNC conversion of PM-30MV

Post your completed retrofits for the world to see.

Moderator: cnckeith

Post Reply
Accu-Slice
Posts: 14
Joined: Mon Oct 18, 2021 11:55 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No

Videos on CNC conversion of PM-30MV

Post by Accu-Slice »

I just recently posted 3 videos on the CNC conversion of my Precision Mathews PM-30MV Mill. For this conversion I used the Centroid Acorn control board and software, the DMM model DYN4 Servos and the Arizona CNC ball screw conversion kit. The three YouTube videos are as follows:

PM-30MV Mill CNC Conversion - Part 1 - Electronics Design and Assembly


PM-30MV Mill CNC Conversion - Part 2 - Installation of Ball screws & Servo Motors


PM-30MV Mill First Project – Part 3


The conversion went quite well thanks to Stephen at DMM, Dave at Arizona CNC, and several responses to my questions on this forum. Also a special thanks to Marty and Franko for their web sites and the information they provided.

My next project will be the conversion of the spindle motor to integrate with the Acorn software. I am not sure how I will proceed on this project.
martyscncgarage
Posts: 9912
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Location: Mesa, AZ

Re: Videos on CNC conversion of PM-30MV

Post by martyscncgarage »

Thank you for sharing your efforts!
Could you post a fresh report here for reference?
Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
Post Reply