Acorn on an Avid pro4848
Posted: Mon Mar 30, 2020 11:08 am
Ok, after looking at this from many angles, and reading so many posts on many sites, I ordered a 48" X 48" ProCNC. All the hardware from AVID and all the electronics, motors, and spindle from Gary Campbell. running Centroid Acorn.
And I have added the rotary too. I will say it has been an adventure to this point, and I am now doing some fine tuning. The basic hardware seems to be very good, and I am happy with the electronics package.
I am not rushing through this, but using what free time I have to complete this.
I can say without a doubt, that the support I have gotten at this point has been great.
And I have added the rotary too. I will say it has been an adventure to this point, and I am now doing some fine tuning. The basic hardware seems to be very good, and I am happy with the electronics package.
I am not rushing through this, but using what free time I have to complete this.
I can say without a doubt, that the support I have gotten at this point has been great.