Centroid Community CNC Support Forum

Hey Folks,

I wanted to post my results in converting my Precision Matthews PM-727 manual mill to a CNC machine using the Acorn board. I built a simple electronics cabinet to house the Acorn board and power supplies. The schematics hook-up published by Centroid for the Teknic drives went without a hitch. I used Misumi low profile 15mm ball screws which allowed me to squeeze the ball nut inside the tables with clearance.

After backlash calibration, I measure less than a thousanth of error over 300mm of travel when using the DRO that came with the mill). Very Nice.
CNC Specs:
Drives: Teknic Servo Drive (SKHP Type)
Power Supply: Dual Teknic IPC-5
Ball Screws: Misumi C5 BSS1505 Low Profile (5mm Lead)
Fixed Mounts: Misumi C5
PC: HP All-in-One (Core i3) Touch Screen

Photos and Videos Posted here:
https://goo.gl/photos/EddCrajE9wguNNAy7

Feel free to PM me if you have a similar mill and want to convert it.

Enjoy,
Mike

Just looked at the photos of your conversion and you really did a nice job.

762x51 wrote: ↑Fri Aug 11, 2017 11:03 am Just looked at the photos of your conversion and you really did a nice job.

I second that! Nice work!
Marty

Thanks for the compliments gentlemen.

That looks like a very fun and capable little machine! You did a fantastic job on that conversion.