Acorn Plasma/Engraver first run

Post your completed retrofits for the world to see.

Moderator: cnckeith

Post Reply
TheKitMill
Posts: 153
Joined: Wed Sep 06, 2017 1:52 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: No
CPU10 or CPU7: No

Acorn Plasma/Engraver first run

Post by TheKitMill »

[media][/media]Plasma/ Engraver 36x36 up and running. It sitting up on Saw horses so i could paint underneath. Acorn did not like turning on and off 100 Amp Thermal dynamics plasma from the Acorn relay board it would fault out the Acorn board but using the Acorn relay to operate secondary relay it worked great. I am rechecking all grounds and installing a grounding rod at the machines new home.

Used Fusion 360 to create the part file and generate the NC file for Acorn

Video to follow:
cnckeith
Posts: 7166
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Contact:

Re: Acorn Plasma/Engraver first run

Post by cnckeith »

cool, thanks for posting..

quencharcs would be good idea.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
Post Reply