Page 1 of 1
Atrump VMC Capabilities
Posted: Fri Nov 15, 2019 12:56 pm
by oakes4501
Just showing off some projects done on some older Atrump VMC's that use Centroid controls.
Re: Atrump VMC Capabilities
Posted: Thu Nov 21, 2019 8:30 pm
by cnckeith
Whoa! nice work..thanks for posting!
Re: Atrump VMC Capabilities
Posted: Fri Dec 20, 2019 11:54 am
by Sportbikeryder
Looks great. I work with an older E320 bed mill with Centroid TRT-32 installed for cylinder head porting. The TRT is a double edged sword as it greatly increases position capability, but at the expense of rigidity. I still used it for quite a bit of our motorcycle parts. Even though the machine is without a tool changer, I think I need to figure out how to add an encoder and rigid tapping as hand tapping off of the machine is starting to get old.
John
Re: Atrump VMC Capabilities
Posted: Fri Dec 20, 2019 7:18 pm
by martyscncgarage
Nice Stuff!
Re: Atrump VMC Capabilities
Posted: Mon Jan 06, 2020 9:16 am
by Sportbikeryder
Atrump parts look even better after a Hard Anodize
Re: Atrump VMC Capabilities
Posted: Thu Jan 23, 2020 10:15 am
by martyscncgarage
Very nice. I just installed a Maximill E216 in my home shop. Super light use. Glad to have it....
Re: Atrump VMC Capabilities
Posted: Thu Jan 23, 2020 11:02 am
by tblough
Looks like I'm not the only one who had to cut a hole in the ceiling to fit in their machine
Re: Atrump VMC Capabilities
Posted: Wed Jan 29, 2020 10:52 pm
by Sportbikeryder
Can even be used to test mechanical fuel pumps if needed