Devlieg Horizontal Retrofit - Took off an unfriendly Dynapath Control and put on a Centroid M400 using a OAK board

Post your completed retrofits for the world to see.

Moderator: cnckeith

Post Reply
cnckeith
Posts: 2932
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
CNC Control System Serial Number: none
Contact:

Devlieg Horizontal Retrofit - Took off an unfriendly Dynapath Control and put on a Centroid M400 using a OAK board

Post by cnckeith »

Arrow Controls Devlieg Horizontal Retrofit - Took off an unfriendly Dynapath Control and put on a Centroid M400 using a OAK board, PLC1616ADD IO and reusing the existing Allen Bradley AC servo drives and AB DC spindle drive.






Finishing up on a retrofit using scale feedback. Initial testing showed axis had .002 to .0075 slop. After turning on and setting up scales we were positioning to less than .0002.

When requesting support READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043

Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.

(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
AnnArborNate
Posts: 20
Joined: Mon Jun 29, 2020 6:18 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: No
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none

Re: Devlieg Horizontal Retrofit - Took off an unfriendly Dynapath Control and put on a Centroid M400 using a OAK board

Post by AnnArborNate »

Awesome. Love seeing these machines. Royal Oak MI right around the corner from me.
Post Reply