Centroid Community CNC Support Forum

solved the issue with the Y axis. The problem turned out to be the encoder cable going to the MPU11 board. The problem would only show up when the cab;e was bent in a certain way. This cable is the only part of the entire system I did not replace, until now.
thank you for all your help.

I was changed back for the benchtest.cnc program. I have to have the faults pins on the H11 connector permanently jumpered because I'm not using the 4th axis right not. This is what I did.I took the phoenix connector from H11 and swapped H13. attached are the setting I used to just try to enable the...

I figured out the invalid character issue. I was following the manual and it said to label all axis drives N instead of X,Y,Z. The part program was looking for X not N. I then had to kill the encoder error messages with 255 in parameter 332-335. This allowed the program to run. The spindle analog ou...

these are my files.
page 28 in the manual for analog out put test.

I'm using teco servo drives and motors. There like sigma 2 copies
750watt. I also did jumper the fault section on the drive plug h13. I had no faults estop pulled in. I will up load the files again not sure what happened.

Knee mill retrofit in the garage MPU11/GPIO4D control. The machine was running great, but the cosmetic side of things needed help. I decided to change the control cabinet location and a few other things. I was given some help by a younger person and 24 volts was accidentally sent to the encoders. I ...