Centroid Community CNC Support Forum

tblough wrote: ↑Tue Dec 05, 2023 10:28 am Tran-torque 1/2” id bushing requires a 7/8 bore. Keyless bushings are far superior to keyways and setscrews.

Precisely my point. The 16T center flange has a diameter of just 0.63" (16mm) so no can do unless another type can be found. Otherwise agree.

For such a small diameter Timing pulley you might struggle to find a suitable locking bush with small enough OD that you could fit to your bored out, original 18T without excessive weakening, if at all. Not sure where you are located but on this side of the pond, 18T pulleys are sold with pilot hole...

Hats off - really nice work

Hats off - really nice work

In reverse order, to allow LAN for folder / file sharing but block ALL Inbound and Outbound Internet traffic using WIn 10 Firewall, refer to following article https://geekoverdose.wordpress.com/2020/06/21/windows-firewall-rule-to-block-internet-but-allow-lan/ Personally, I allow Internet access from...

Look up peer to peer networking with Win10/11 to share required folders. Interdict internet access with your CNCPC firewall

I don't use Clearpath servos so I may be a million miles away. Are you sure the Clearpath Input Resolution is correctly set to 6400 thereby matching your Acorn settings?

Very interesting Uwe. FWIW, FreeCad directly supports import of Point Clouds and is fully parametric / completely free. I use FC for all my 3D additive modelling but not for Machining - it could be a useful and (cost free) intermediate step for your processing. FC Points Import currently supports .a...

and if not using fixed tool holders you can do this with Swissi's ProbeApp

Thanks Uwe