Centroid Community CNC Support Forum

this may interest you as well.

i moved this thread into the acorn forum

in the photo it looks like the bore is moving +X and - Y in all cases , is this true?

I have extra ball nuts so I can try a double nut setup, but first I need to make sure where the backlash is coming from. It may also be coming from the fixed bearing block. I swapped the bearings for angular contact, and added a bearing shim to get some pre-load. Is 0.0005" backlash a lot? gre...

software pairing does not require the user to enter the axis data in the 4th axis, by definition both should be the same, so you can do it if it makes you feel good but the Wizard/CNC12 are going to assume the slave axis is the same as the master axis and use the data entered from the master axis. a...

having a button that closes the input is the easiest to under stand in this case. for cyclestart2,feedhold2 buttons in the wizard i have my button input set green which = do the logic assigned to the input when input is made. my button closes the input when depressed. when button is depressed the LE...

The Thread angle is the compound angle, not the angle of the insert. Compound angle controls the angle that the control adjust how the cutting on the insert is done. 59 (29 1/2) adjusts the cut so most of the cut is done on the leading side of the insert. With compound angle of 0.0 the insert will ...

have you asked Teknic? i hear they are good with support.

yeah, put them in any folder you want. no problem.

sounds good. the tool library in cnc12 is going to get a make over in v5.2 for mill and router 1st stage of this make over will be in v5.18 which will be a router only release . That is not fair, I have no router yet 🤣 Tool Lib is for me less a problem than not having second independent spindle wit...