Centroid Community CNC Support Forum

The width of the probe is only for auto measure ZX, so after measuring Z the CNC knows the center of the probes width. Measuring drills in X with the probe is a "bad habit", because if the drill edge is not exactly set in height you get wrong values, set X0 of the toolholder with a dial in...

Depends on the bearing grease, I use Isoflex NBU 15, thats good from -40 to 130C My spindle is reaching 45-50C fast and stays there even if I run jobs with 6000 rpm 16h a day. If your spindle temp keeps rising and will nor equal out at some point, I would stop at 80C, dismantle, clean and fill with ...

Yeah, I have had a really hard time to keep my printed documentation up to date

One reason my CNCs are now dual monitor...

Uwe

phazertwo wrote: ↑Sat Feb 17, 2024 2:43 pm Chief_hacker you are a life saver!

I have been fighting com issues since I updated CNC12 last month... so frustrating!

I agree that this should be added to the COM issues tech bulletin.

PZ

Did you read the current version?

Uwe

Sure, here it is

Uwe

Tomorrow was two days ago

https://centroidcncforum.com/viewtopic.php?f=67&t=9808

Uwe

I would wait for the upcoming USB BOB

https://centroidcncforum.com/viewtopic.php?f=67&t=9747

Uwe

These are Leadshine Servos, driver is without 0-10V input.

They work fine with Acorn, 200khz on Headers and up to 500 khz on DB25.

Easy to wire, because all screw terminals no soldering for a custom cable.

Uwe

Glad that it runs now smooth.

Resonance is maybe from the belt, try to get a bit more tension.

Uwe

Not now, should have looked closer...

https://alibre.info/kontakt.html

Uwe