Centroid Community CNC Support Forum

Hi,
I having difficulties setting up the latest version of CNC12 with ProbeApp. Not sure what configuration information I need to change. I have attached a picture of the error message as well as a copy of the latest report.
Thanks

The fault was caused by a bad motor. It has been repaired. The wiring has been chnged and all is working properly.

I wound up not wiring the contactor to the C86. I had it where you had to start CNC12 to engage the contactor and the C86 board. The C86 board would work until a motor faulted and instead of the motors all stopping just the remaining unfaulted motors would continue moving. For whatevere reason the t...

Does ProbeApp 3.32 work with the new version of CNC12?
Thanks

We all have remember that Microsoft patch Windows all the time. It is possible that one type of instruction is given a higher priority of execution over another regardless of order. They never disclose these things to software developers. It could be as simple as a registry fix but not knowing how i...

I will try the latest suggestions. I found that if you exit cnc12 and then shut down the problem doesn't occur. Believe for some reason a instruction is trying to shut down the computer before the VCP has had a chance to close. Is there a way for us to increase the time for the VCP to close before t...

At least I am not the only one. Hopefully one of usfinds a solution. I will keep you posted.

Hi,
This message appeared at a shut down of windows when I chose to shut down computer from the Acorn menu. Does anyone know what could be causing this?

Got it working. When the motor faults, should the reset button be highlighted in white? Thanks

I am trying to get all motors to stop if there is a fault on any one motor. Cureently, that isn't happening, the other two motors keep running.
Thanks